Cube L4-1.8L (MR18DE) (2010)
Clockspring Assembly / Spiral Cable: Service and Repair
Removal And Installation
SPIRAL CABLE
Removal and Installation
WARNING:
-
Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more.
-
Never use the air tools or electric tools for servicing.
REMOVAL
1. Remove the driver air bag module. See: Air Bag/Service and Repair/Driver Air Bag Module/Removal And Installation.
2. Remove the steering wheel. See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Removal and Replacement/Removal And
Installation.
3. Remove the steering column cover. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel Assembly.
4. Disconnect the spiral cable body side harness connectors (A) and steering angle sensor harness connector (B).
5. Remove the spiral cable fixing screws.
Broken Triangle : Pawl
6. Disengage the pawls with flat-bladed screwdriver, and then pull out forward the spiral cable and steering angle sensor.
CAUTION:
-
Never impact the spiral cable.
-
Replace the spiral cable if it has been dropped or sustained an impact.
-
Never disassemble the spiral cable.
-
Never apply lubricant to the spiral cable.