Cube L4-1.8L (MR18DE) (2010)
2. Remove the fixing nut (A), and pull back crash zone sensor (1) and bracket (2).
3. Disconnect the crash zone sensor harness connector.
CAUTION:
-
Never impact the crash zone sensor.
-
Replace the crash zone sensor if it has been dropped or sustained an impact.
-
Replace the crash zone sensor of deployed SRS driver air bag and deployed SRS front passenger air bag.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Never use the old fixing nut after removal, replace with the new nut.
-
Never damage the harness while installing.
-
Always install normally aligning to the cutout hole, because performance of the crash zone sensor excessively fluctuates according to the
installation position.
-
If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using
self-diagnosis or CONSULT-III. See: Testing and Inspection/Scan Tool Testing and Procedures/Diagnosis System (Air Bag),
-
After the work is completed, check that no system malfunction is detected by air bag warning lamp.