Cube L4-1.8L (MR18DE) (2010)
Steering Angle Sensor: Testing and Inspection
Adjustment Of Steering Angle Sensor Neutral Position
Description
ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
Description
When doing work that applies to the list below, make sure to adjust neutral position of steering angle sensor before running vehicle.
Special Repair Requirement
ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
Special Repair Requirement
ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
CAUTION:
To adjust neutral position of steering angle sensor, make sure to use CONSULT-III.
(Adjustment cannot be done without CONSULT-III.)
1.ALIGN THE VEHICLE STATUS
Stop vehicle with front wheels in straight-ahead position.
- GO TO 2.
2.PERFORM THE NEUTRAL POSITION ADJUSTMENT FOR THE STEERING ANGLE SENSOR
1. Select "ABS", "WORK SUPPORT" and "ST ANGLE SENSOR ADJUSTMENT" in order with CONSULT-III.
2. Select "START".
CAUTION:
Never touch steering wheel while adjusting steering angle sensor.
3. After approximately 10 seconds, select "END".
NOTE:
After approximately 60 seconds, it ends automatically.
4. Turn the ignition switch OFF, then turn it ON again.
CAUTION:
Be sure to perform above operation.
- GO TO 3.
3.CHECK DATA MONITOR
1. Run the vehicle with front wheels in straight-ahead position, then stop.
2. Select "ABS", DATA MONITOR" and "STR ANGLE SIG" in order with CONSULT-III, and check steering angle sensor signal.
STR ANGLE SIG : 0±2.5°