Cube L4-1.8L (MR18DE) (2010)
Shift Interlock Cable: Service and Repair
Removal And Installation
KEY INTERLOCK CABLE
Removal and Installation
REMOVAL
CAUTION:
Make sure that parking brake is applied before removal/installation.
1. Remove selector lever knob. See: Shifter CVT/Service and Repair/Exploded View.
2. Remove center console. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Center Console Assembly/Exploded View.
3. Slide slider (A) toward casing cap (B) while pressing tabs (C) on slider to separate slider from adjust holder (D).
E : Key interlock rod
4. Remove steering column cover lower and instrument driver lower panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Exploded View.
5. Pull out the lock plate (A) from the holder (B).
6. Remove the key interlock cable (1) from the key cylinder (2).
7. Remove clip and remove key interlock cable.
INSTALLATION
Note the following, and install in the reverse order of removal.
-
Temporarily install adjust holder (A) to key interlock rod (B). Install casing cap (C) to cable bracket (D) on CVT shift selector assembly.