D21 Hardbody 2WD L4-2389cc 2.4L SOHC MFI (KA24E) (1990)
Brake Rotor/Disc: All Technical Service Bulletins
Brakes - Ammco On Car Brake Lathe Operating Guidelines
Classification:
BR92-004
Section:
Brake
Reference:
TECHNICAL BULLETIN NTB92-062
Models:
All models
Date:
August 18, 1992
AMMCO ON-CAR BRAKE LATHE OPERATING GUIDELINES
APPLIED MODEL:
All models
SERVICE INFORMATION
To ensure the best possible surface finish and least amount of run-out and rotor thickness variation when using the Ammco on-car brake lathe, the
following guidelines should be observed.
SERVICE PROCEDURE
Before mounting the brake lathe on the vehicle ensure the following:
1.
The V-way between the carriage and carriage jib must be clean and adjusted properly (see Operation Manual for adjustment procedure). Wipe off
sliding surfaces with a soft cloth after each use.
2.
The cutters and cutting bits must be tight in their mounts and positioned properly. Change cutting bits when they become dull.
3.
When securing the adjustable mounting brackets to the caliper mount/knuckle the mounting surfaces must be smooth and free of burrs.
4.
Make sure the adjustable mounting brackets are securely mounted to caliper mount/knuckle. There should be no movement between the cutting
tool and the caliper mount/knuckle.
Rotor Driving Unit Before using the drive unit ensure the following: