D21 Hardbody 2WD L4-2389cc 2.4L SOHC MFI (KA24E) (1990)
![background image](/nissan/d21_hardbody_2wd/l4-2389cc_2.4l_sohc_mfi_(ka24e)/Page-154002.png)
1.
Remove air cleaner assembly and detach engine harness from engine (section between valve cover and throttle body). (Figure 2)
2.
Remove the harness covering (plastic shield/electrical tape) and locate the splice connection. A single ground wire (B/G) is connected to three
other wires (also, B/G) with a pressed metal connector.
To ensure a positive connection at this splice, solder the metal connector to the wires to form a permanent connection (Figure 3).
3.
Wrap soldered splice with heat shrink tape to ensure a waterproof seal. Reinstall plastic shield and wrap with 3M Electrical Tape (3M P/N 88) or
equivalent.
4.
Reattach harness to engine and replace air cleaner assembly.
5.
Test drive vehicle to ensure that incident is resolved.
WARRANTY INFORMATION