D21 Hardbody 2WD V6-2960cc 3.0L SOHC MFI (VG30E) (1991)
Antitheft and Alarm Systems: Technical Service Bulletins
Antitheft - Security System Installation Tips
Classification:
EL91-001
Section:
Electrical System
Reference:
TECHNICAL BULLETIN NTB91-010
Models:
1988 & later Truck (D21)
Date:
January 31, 1991
VEHICLE SECURITY SYSTEM FOR TRUCKS
APPLIED MODELS: 1988 and later Truck (D21)
SERVICE INFORMATION
Some 1988 and later Trucks do not have a right door switch to actuate the interior lights. Therefore, when installing the V.S.S. on these vehicles, use the
following instructions to complete the installation.
VEHICLES WITH DOOR SWITCH HARNESS
Some trucks have no right door switch factory installed but may be equipped with the harness branch and connector. Install door switch (P/N
25360-41L00), and cover (P/N 25368-41L00), to complete the V.S.S. installation.
VEHICLES WIETHOUT DOOR SWITCH HARNESS
Some trucks have no right door switch or harness branch. Use the V.S.S. trunk pinswitch (i.e. the extra pinswitch which is included for mounting in the
trunk on sedan installations), and the black V.S.S. trunk switch wire. Complete the installation as follows:
1.
Remove the right "B" pillar finisher.
2.
Mark and drill an 11/32" hole 1-1/4" below existing cover (see illustration). Apply Nissan rust preventative to the exposed metal.
3.
Install the pinswitch. Route the black VSS trunk switch wire under the carpet and plug into the rear of the switch.
4.
Cut the black VSS trunk wire near the VSS connector. Attach this black wire to the gray VSS wire with a red Scotchlok so the left and right door
switches are wired together. Fold back and tape up the remaining end of the black wire so the exposed wire does not contact any metal.
NOTE:
In addition to completing the V.S.S. installation, the right door will now operate the dome light.
PARTS INFORMATION (For vehicles with door switch wire harness)
PART NAME
PART NUMBER
Door Switch Assy.
25360-41L00
Door Switch Cover
25368-41L00