D21 Hardbody 4WD V6-2960cc 3.0L SOHC (VG30i) (1986)
15.
Slide the striking rod the other way to free the reverse shift fork.
REVERSE COUPLING
16.
Slide the reverse coupling sleeve off the mainshaft.
COUPLING SLEEVE
17.
Install the new reverse coupling sleeve onto the mainshaft.
CAUTION:
Splines on coupling sleeve should point towards the adapter plate.
INSTALLING RETAINING PIN
18.
Install the new reverse shift fork and slide the striking rod through the hole. Then install a new retaining pin into the striking lever. NOTE
DIRECTION of striking interlock. Make sure striking rod moves smoothly.
CAUTION: Use the correct factory retaining pin (2 pins, one inside the other).
19.
Install the O.D./reverse fork rod and retaining bolt.
Apply lock sealant to threads of bolt.