D21 Hardbody SE King Cab 4WD L4-2389cc 2.4L SOHC MFI (KA24E) (1997)
10.50PE Page 9
9.
Spray 2 to 3 coats of Diamont Clear DC88 or 89 / DH44 / 891 flex at 4:1:1 (or compliant clear for VOC regulated areas).
Allow 5 minutes flash time between coats. If baking, allow 15 minutes flash time before baking.
10.
Allow to cure overnight or bake at 140° F for 30 minutes.
Sherwin Williams Procedures
Bumper Cover Preparation PUR or PP
1.
Wash and rinse with detergent and water.
2.
Wipe with AQUA-MATE Low VOC Cleaner W4-K157.
3.
Scuff sand bumper covers with gray nylon scuff pad.
4.
To ensure all mold release agent is removed the bumper can be heated at 1400 F for 45 minutes. Allow bumper to cool completely before
cleaning.
5.
Re-clean with AQUA-MATE Low VOC Cleaner W4-K157.
Coating PUR (polyurethane) bumper covers
6.
Apply ULTRA-FILL II Acrylic Urethane Sealer E6-C61 or E6-H59 with MULTI-FLEX Urethane Flexible Additive V6-V299 according to label
directions.
7a.
Basecoat/Clearcoat Procedures
1.
Apply ULTRA-7000 Basecoat Color.
2.
Apply ULTRA-7000 Clearcoat over ULTRA-7000 Basecoat using MULTI-FLEX Urethane Flexible Additive V6-V299 according to label
directions.
7b.
NON Basecoat/Clearcoat Procedures
Apply ULTRA-ONE STAGE Acrylic Urethane with MULTI-FLEX Urethane Flexible Additive V6-V299 according to label directions.
Coating PP (polypropylene) bumper covers
6.
Apply one coat of Plastic Primer UPO-7224 according to label directions.
7.
Apply ULTRA-FILL II Acrylic Urethane Sealer E6-C61 or E6-H59 with MULTI-FLEX Urethane Flexible Additive V6-V299 according to label
directions.
8a.
Basecoat/Clearcoat Procedures
1.
Apply ULTRA-7000 Basecoat Color.
2.
Apply an ULTRA-7000 Clearcoat over ULTRA-7000 Basecoat using MULTI-FLEX Urethane Flexible Additive V6-V299 according to
label directions.
8b.
Non Basecoat/Clearcoat Procedures
Apply ULTRA ONE STAGE Acrylic Urethane with MULTI-FLEX Urethane Flexible Additive V6-V299 according to label directions.
Coating PUR (polyurethane) or PP (polypropylene) bumper covers
5.
Apply 1 - 1-1/2 coats of Priomat Elastic Primer 3304. Allow to dry for 10-15 minutes.
6.
Apply two 3 coats of Priomat Elastic Primer Filler 3305. The mix is 2 parts 3305 and 1 part 8581.
7.
Allow to dry for 20 minutes.
8.
Top coat with any Spies Hecker Top Coat.