D21 Hardbody SE King Cab 4WD L4-2389cc 2.4L SOHC MFI (KA24E) (1997)
-
Remove the snap ring using external snap ring pliers.
-
Pulley removal
Use any commercially available pulley puller. Position the center of it on the end of the drive shaft and remove the pulley assembly.
For pressed pulleys:
To prevent deformation of the pulley groove, the puller claws should be hooked under (not into) the pulley groove.
For machine latched pulleys:
Align the pulley puller groove with the pulley groove and then remove the pulley assembly.
-
Remove the field coil harness clip using a screwdriver.
-
Remove the three field coil fixing screws and remove the field coil.
INSTALLATION
-
Install the field coil.
-
Be sure to align the coil's pin with the hole in the compressor's front head.
-
Install the field coil harness clip using a screwdriver.