D21 Hardbody XE 4WD L4-2389cc 2.4L SOHC MFI (KA24E) (1997)
Bumper Cover Preparation PUR (polyurethane)
1.
Bake for 60 minutes at 140°F (60°C) to temper the plastic.
2.
Clean the plastic several times using a Gray Scotch Brite pad and Standoflex 11100 Thinner anti-static cleaner. Use a clean pad and fresh thinner
with each cleaning.
3.
Re-temper for 20 minutes at 140°F (60° C).
4.
Apply Stopper if necessary (3M 5900).
5.
Apply Standox Pore Filler on PUR foam.
6.
As a final clean before priming, use fresh standoflex 11100 Thinner anti-static cleaner with a clean towel.
Coating PP (polypropylene) bumper covers
5.
Mix Standoflex 11816 2K Plastic Filler 1:1 with 11824 2K Plastic Filler Hardener.
6.
Spray 2 coats of the mixture onto the bumper cover.
7.
Let stand for 20 minutes.
8a.
Basecoat/Clearcoat colors
Mix 2K Standocryl (Single Stage) with 30% 2K Elastic Additive.
Add 2K Hardener and Thinner.
Apply 2 coats.
8b.
Basecoat/Clearcoat colors
Apply Standox Basecoat.
Mix Standox 2K Clear with 30% 2K Elastic Additive.
Add 2K Hardener and Thinner.
Apply 1 or 2 coats (depending on Clear being used).
Coating PUR (polyurethane) bumper covers
7.
Mix Standoflex 11816 2K Plastic Filler 1:1 with 11824 2K Plastic Filler Hardener.
8.
Spray 2 coats of the mixture onto the bumper cover.
9.
Let stand for 20 minutes.
10a. NON Basecoat/Clearcoat colors
Mix 2K Standocryl (Single Stage) with 100% 2K Elastic Additive.
Add 2K Hardener and Thinner.
Apply 2 coats.
10b. Basecoat/Clearcoat colors
Apply Standox Basecoat.
Mix Standox 2K Clear with 100% 2K Elastic Additive.
Add 2K Hardener and Thinner.