D21 Hardbody XE 4WD L4-2389cc 2.4L SOHC MFI (KA24E) (1997)
Page 4
2.
Clearcoat Chroma Base Basecoat with Chroma Clear High Glamour 7800S or Chroma Clear MULTI Use 75005.
6b.
NON Basecoat/Clearcoat Procedures
Topcoat with Chroma One Single Stage according to label direction.
BASF Glasurit Procedure
Bumper Cover Preparation PUR or PP
1.
Pre-baking the bumper cover at l40°F for 45 minutes will improve adhesion.
2.
Wash the bumper cover with soap and water.
3.
Dry with paper towel and lint-free cloth.
4.
Wash with Glasurit 541-30 Universal Plastic Cleaner to remove wax, silicone and contaminates.
Dry with paper towel.
5.
Scuff the entire bumper cover with gray Scotchbrite pad.
6.
Wash off residue with 541-30.
7.
Allow to dry completely with lint-free cloth.
Coating PUR (Polyurethane) bumper covers
8.
Apply 1 thin uniform coat of Glassofix 934-01K Plastic Adhesion Primer.
9.
Allow 15 to 20 minute flash time.
10.
Apply Glasurit L-21 or L-54 to hiding. In the case of L-21, use 40 volume parts of Glassodur 521-111 Elastifier Additive according to procedure.
11.
In the case of L-54, allow 15 to 20 minutes flash time.
12.
Apply either Glassodur 923-54 or 923-85 with 20 volume parts Glassodur 521-111 Elastifier Additive according to label directions (or compliant
clear for VOC regulated areas).
Coating PP (Polypropylene) bumper covers
8.
Apply 1 thin uniform coat of Glassodur 285-02K Transparent Filler.
9.
Allow 15 to 20 minute flash time.
10.
Apply a thin coat of Glassodur 285-75 Tintable Primer if necessary.
11.
Apply Glasurit L-21 or L-54 to hiding. In the case of L-21, use 40 volume parts of Glassodur 521-111 Elastifier Additive according to procedure.
12.
In the case of L-54 allow 15 to 20 minutes flash time.
13.
Apply either Glassodur 923-54 or 923-85 with 20 volume parts Glassodur 521-111 Elastifier Additive according to label directions (or compliant
clear for VOC regulated areas).
Herberts Standox Procedures
Bumper Cover Preparation PP (polypropylene)
1.
Bake for 60 minutes at 140°F (60°C) to temper the plastic.
2.
Clean the product several times using a Gray Scotch Brite pad and Standoflex 11100 Thinner anti-static cleaner (use a clean pad and fresh thinner
with each cleaning.).
3.
Allow to dry completely.
4.
As a final clean before priming, use fresh Standoflex 11100 Thinner anti-static cleaner with a clean towel.