D21 Hardbody XE 4WD L4-2389cc 2.4L SOHC MFI (KA24E) (1997)
/Page-2140001.png)
Diagnosis Sensor Unit: Service and Repair
CAUTION:
^
Before servicing SRS, turn the ignition switch OFF, disconnect both battery cables and wait for at least 3 minutes.
^
The special bolts are coated with a bonding agent while the other bolt is for ground. Do not use old bolts after removal; replace with new coated
bolts.
^
Check diagnosis sensor unit for proper installation.
^
Check diagnosis sensor unit to ensure that there are no deformities, dents, cracks or rust. If there are any visible signs of damage, replace with a
new one.
^
Check diagnosis sensor unit brackets to ensure they are free of deformities and rust.
^
Replace diagnosis sensor unit if it has been dropped or sustained an impact.
^
Check crash zone sensor for proper installation.
^
Check crash zone sensor to ensure that there are no deformities, dents, cracks or rust. If there are any visible signs of damage, replace the crash
zone sensor.
^
Check crash zone sensor bracket to ensure that it is free of deformities and rust.
CAUTION: Before servicing SRS, turn the ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
Diagnosis Sensor Unit
Diagnosis Sensor Unit
1. Disconnect driver air bag module connector.
2. Remove console box.
3. Disconnect diagnosis sensor unit connector.
4. Using the TAMPER RESISTANT TORX (Size T50), remove the three special bolts, then remove ground bolt. The diagnosis sensor unit can then
be removed.
NOTE: To install, reverse the removal procedure.
