D21 Hardbody XE 4WD L4-2389cc 2.4L SOHC MFI (KA24E) (1997)
2. If turning torque is not within specifications, adjust by turning sector shaft adjusting screw.
3. Tighten adjusting screw lock nut with tools.
Pre-Disassembly Inspection
Before disassembling power steering gear component parts, make sure there is no oil leakage around sealing portion and check steering turning torque
as follows: Check sealing portion.
^
Sector shaft cover O-ring
^
Sector shaft U-packing
^
Sector shaft oil seal
^
Rear housing O-ring
^
Gear housing O-ring
NOTE:
^
Discard any oil seal and O-ring which have been removed.
^
Replace oil seal and O-ring if sealing surface is deformed or cracked.