D21 Hardbody XE 4WD L4-2389cc 2.4L SOHC MFI (KA24E) (1997)
Low & Reverse Brake Drive Plates
-
Check facing for burns, cracks or damage.
-
Measure thickness of facing. If not within wear limit, replace.
Thickness of drive plate:
Standard value: 1.52 - 1.67 mm (0.0598 - 0.0657 inch)
Wear limit: 1.8 mm (0.071 inch)
Low One-Way Clutch Inner Race
-
Check frictional surface of inner race for wear or damage.
-
Install new seal rings onto low one-way clutch inner race.
-
Be careful not to expand seal ring gap excessively.
-
Measure seal ring-to-groove clearance. If not within allowable limit, replace low one-wary clutch inner race.
Inspection standard:
Standard value: 0.10 - 0.25 mm (0.0039 - 0.0098 inch)
Allowable limit: 0.25 mm (0.0098 inch)
ASSEMBLY
1. Install needle bearing onto one-way clutch inner race.
-
Pay attention to its direction-Black surface goes to rear side.
-
Apply petroleum jelly to thrust washers.
2. Install oil seal and D-ring onto piston.
-
Apply ATF to oil seal and D-ring.