Frontier 2WD L4-2.5L (QR25DE) (2005)
6. Disconnect A/T fluid cooler hoses. (A/T models). Install blind plug to avoid leakage of A/T fluid.
7. Remove the upper mount bracket bolts.
8. Remove the two A/C condenser bolts. (if equipped)
9. Remove radiator as follows:
CAUTION: Do not damage or scratch A/C condenser and radiator core when removing.
a. With lifting and pulling radiator in a rear direction, disassemble lower mount from radiator core support center.
CAUTION: Because A/C condenser is onto the front-lower portion of radiator, moving to rear direction should be at minimum.
b. Lift A/C condenser up and remove radiator after disengaging the fitting as front-bottom surface.
CAUTION: Lifting A/C condenser should be minimum to prevent a load to A/C piping.
c. After removing radiator, put A/C condenser on radiator core support center to prevent a load to A/C piping, and temporarily secure it with rope
or by similar means.
INSTALLATION
Installation is in the reverse order of removal.
INSPECTION AFTER INSTALLATION
^
Check for leaks of engine coolant using tool. Refer to CHECKING COOLING SYSTEM FOR LEAKS.