Frontier 2WD L4-2.5L (QR25DE) (2005)
Evaporator Temperature Sensor / Switch: Service and Repair
INTAKE SENSOR
Removal and Installation
REMOVAL
1. Remove the front kick plate. Refer to "KICK PLATES".
2. Remove the lower dash side finisher. Refer to "LOWER DASH SIDE FINISHER".
3. Remove the front pillar lower finisher. Refer to "FRONT PILLAR LOWER FINISHER".
4. Remove the assist grip handle
5. Remove the front pillar upper finisher. Refer to "FRONT PILLAR UPPER FINISHER".
6. Remove the lower glove box. Refer to "LOWER INSTRUMENT PANEL RH AND GLOVE BOX".
7. Remove the upper glove box (cluster lid E). Refer to "INSTRUMENT PANEL ASSEMBLY".
8. Disconnect the intake sensor electrical connector.
NOTE: The intake sensor is located on the top of the heater and cooling unit assembly next to the A/C evaporator cover.
9. Twist the intake sensor to remove the intake sensor from the heater and cooling unit assembly.
INSTALLATION
Installation is in the reverse order of removal.