Frontier 2WD V6-4.0L (VQ40DE) (2009)
Drive/Propeller Shaft: Procedures
Propeller Shaft 2S1330
PROPELLER SHAFT
On-Vehicle Service
APPEARANCE AND NOISE INSPECTION
-
Check the propeller shaft tube surface for dents or cracks. If damaged, replace the propeller shaft assembly.
-
Check the bearings for noise and damage. Repair or replace the bearings as necessary.
PROPELLER SHAFT VIBRATION
If a vibration is present at high speed, inspect the propeller shaft runout first.
1. Measure the runout of the propeller shaft tube at several points by rotating the final drive companion flange with your hands. Refer to See:
Specifications/General Specification/Propeller Shaft 2S1330.
2. If the runout exceeds specifications, disconnect the propeller shaft at the final drive companion flange; then rotate the companion flange 90°, 180°
and 270° and reconnect the propeller shaft.
3. Check the runout again. If the runout still exceeds specifications, replace the propeller shaft assembly.
4. After installation, check for vibration by driving vehicle.
Propeller Shaft 3S1310
REAR PROPELLER SHAFT
On-Vehicle Service
APPEARANCE AND NOISE INSPECTION
Check the propeller shaft tube surface for dents or cracks. If damaged, replace the propeller shaft assembly.
PROPELLER SHAFT VIBRATION
If a vibration is present at high speed, inspect the propeller shaft runout first.