Frontier SE Crew Cab 4WD V6-3.3L (VG33E) (2000)
10. Firmly press the Paint Protector Film onto the vehicle with the squeegee.
11. If present, remove any plugs from the Air Dam mounting holes in the truck's roof rack.
CAUTION: Take care not to bump or move the Paint Protector Strip. It will still be wet and not firmly glued into place.
12. Place the Air Dam across the front of the roof rack side rail assemblies and align the Air Dam slots with the threaded inserts found in the side rail
assemblies.
13. Install 4 Torx screws through the Air Dam slots into the side rail threaded inserts. Tighten the screws by hand to 3.0 ft. lbs., or 1 extra turn after
the screw is seated in place. Do not overtorque the screws.
NOTE: There should be no visible gap between the Air Dam Seal and the roof.
PARTS INFORMATION
CLAIMS INFORMATION
Submit a "CM" line claim using the following claims coding information:
"CM" I.D.: B0072
NOTE: This claim coding applies ONLY to the VINs as identified in Service Comm with the "CM" I.D. of "B0072".
OWNER LETTER