Frontier SE King Cab 4WD L4-2.4L (KA24DE) (1998)
NOTE:
Do not over-tighten the machine bolt when reinstalling it.
3.
Remove the self-tapping screw from body ground M14 (located behind the driver's side kick panel) and clean the contact surfaces of the ground
wire eyelet and body panel as necessary to ensure metal-to-metal contact (see Figure 2). Reinstall the screw carefully to avoid damaging the
threads.
NOTE:
If the body threads are stripped, install a slightly larger self-tapping screw to secure the body ground wire eyelet.
4.
Replace the fuel sender located in the fuel tank.
NOTE:
The fuel sending unit can be accessed by either removing the fuel tank from the bottom of the vehicle or removing the truck bed from the top of the
vehicle. Before removing the bed, make sure there is sufficient space around the vehicle to safely remove and store the bed. If the fuel tank is
removed, refer to the FE section in the appropriate service manual for instruction on removing the fuel tank/fuel sender.
NOTE:
The following step (step # 5) only applies to vehicles built before January 1, 1999.
5.
Replace the speedometer assembly*. Refer to the BT section in the appropriate service manual.
* The speedometer assembly includes the unified control meter, which controls the fuel gauge, speedometer, engine temperature gauge, odometer and
tachometer (it equipped).
NOTE:
Conform to local laws regarding speedometer/odometer replacement. A new speedometer/unified control meter with the odometer set to the correct
mileage may be ordered as described in Claims Bulletin WB/98-017.
PARTS INFORMATION
NOTE:
The speedometer assemblies listed above must be ordered as described in Claims Bulletin WB/98-017.