Frontier XE King Cab 2WD L4-2.4L (KA24DE) (2000)
Center Support: Technical Service Bulletins
Driveshaft - Center Bearing Replacement Procedure
Classification:
PD99-002
Reference:
TB00-025
Date:
March 10, 2000
1998-2000 FRONTIER AND 2000 XTERRA PROPELLER SHAFT CENTER BEARING REPLACEMENT
APPLIED VEHICLES:
1998-2000 Frontier (D22)
2000 Xterra (WD22)
SERVICE INFORMATION
If the propeller shaft center bearing must be replaced on a 1998-2000 Frontier or 2000 Xterra, center bearing kits are now available as shown in the
PARTS INFORMATION Section of this bulletin.
Use the appropriate Service Manual for details on disassembly and re-assembly of the propeller shaft, but be sure to align the shaft as shown in Propeller
Shaft Alignment instructions below.
NOTE:
This is the ONLY approved repair procedure for this incident. A claim to Nissan for the repair of this incident may be denied if the repair is not
performed exactly as outlined in this bulletin.
Propeller Shaft Alignment:
It is very important that alignment be marked when disassembling the two parts of the propeller shaft. Failure to ensure propeller shaft alignment
throughout the service procedure may affect balance of the propeller shaft.
1.
When disassembling the propeller shaft, place an alignment mark on the propeller shaft and yoke (see Figure 1).