Frontier XE King Cab 4WD L4-2.4L (KA24DE) (1998)
4. While moving the connector, check whether the male terminal can be easily inserted or not.
^
If the male terminal can be easily inserted into the female terminal, replace the female terminal.
How to Probe Connectors
Connector damage and an intermittent connection can result from improperly probing of the connector during circuit checks. The probe of a Digital
Multimeter (DMM) may not correctly fit the connector cavity. To correctly probe the connector, follow the procedures below using a "T" pin. For the
best contact grasp the "T" pin using an alligator clip.
Probing From Harness Side
Standard type (not waterproof type) connector should be probed from harness side with "T" pin.
^
If the connector has a rear cover such as a ECM connector, remove the rear cover before probing the terminal.
^
Do not probe waterproof connector from harness side. Damage to the seal between wire and connector may result.
Female Terminal
There is a small notch above each female terminal. Probe each terminal with the "T" pin through the notch.
^
Do not insert any object other than the same type male terminal into female terminal.