Juke AWD L4-1.6L Turbo (MR16DDT) (2011)
2. When you get to the ECM Reprogramming screen shown in Figure 1 above, confirm this bulletin applies as follows:
A. On your C-III screen, look at the Part Number column (see Figure 1):
^
If this column is blank (no part number listed), this campaign does not apply or it has already been done. Close C-III and disconnect from the
vehicle, then recheck Service Comm for campaign eligibility.
^
If a Part Number is listed, write it on the Repair Order.
B. Compare the Part Number you wrote down to the number in the Current ECM Part Number list in Table A above.
^
If there is a match, this bulletin applies. Continue with the reprogramming procedure.
NOTE:
If there is a match to two lines (two reprogramming options) on your C-III screen, use the one that does not have the message "Caution! Use ONLY with
NTBXX-XXX".
^
If there is not a match, this campaign does not apply or it has already been done. Close C-III and disconnect from the vehicle, then recheck Service
Comm for campaign eligibility.