Leaf ELE-Electric Engine (2011)
2. When the plus VI firmware update has completed, select Sub mode.
3. Verify the plus VI firmware version is 3.00.68
^
To get to the screen above, go to "Reprogram VCM (Vehicle Control Module), and then follow steps 1a - 1c.
4. If the plus VI Firmware version is NOT 3.00.68, perform plus VI Firmware installation again.
GR8 Multitasking Battery Diagnostic Station Setup
GR8 Multitasking Battery Diagnostic Station Setup
1. Connect the battery tester/charger to the 12 V battery, positive cable first.
2. Plug in the battery tester/charger (AC voltage supply), and then turn on the battery tester/charger.
3. Select the preferred language, and then depress NEXT.
4. Select the USER, and then depress NEXT.
5. Confirm the USER, and then depress NEXT.
