Maxima V6-3.5L (VQ35DE) (2007)
5. Peel off the top (smaller) backing sheet from one of the fluorine resin tapes (see Figure 5).
^ Two fluorine resin tape pieces are provided in the kit.
6. Place the fluorine resin tape (adhesive side toward you) against the seat belt as shown in Figure 6A.
NOTE:
^ The sticky half should be down, toward the floor of the vehicle.
^ The unexposed (not sticky yet) half should be up, toward the ceiling of the vehicle.
Note the following before performing steps 7 and 8:
^
Once the fluorine resin tape is applied to the "D" ring, it cannot be repositioned.
^
Take care to properly attach the tape to the "D" ring.
^
Center the tape correctly on the "D" ring and smoothly apply it to the "D" ring surface so that no wrinkles or ridges are present.
^
Wrinkles or ridges in the tape may prevent the seat belt from moving smoothly through the "D" ring. If this should occur, replace the tape with a
new piece.
7. Pull on the top of the seat belt to roll the tape up and around the "D" ring (see Figure 6B).