Maxima V6-3.5L (VQ35DE) (2007)
Steering Gear: Adjustments
Adjustment for Rack Sliding Force
DECREASE
Decrease rack sliding force as follows:
1. Loosen adjusting screw two rotations counterclockwise.
CAUTION:
^
Do not remove adjusting screw.
^
Steering gear must replaced if adjusting screw is removed or loosened more than two rotations.
2. Tighten adjusting screw in 40° - 60° increments until rack sliding force is within specification. Refer to PS-32, "Steering Gear and Linkage". See:
Specifications/Steering Gear and Linkage
NOTE: Steering gear must be replaced if adjusting screw rotation torque is less than 5.0 Nm (0.9 kg-m, 44 in-lb).
3. Verify rack sliding force. Refer to PS-18, "CHECKING RACK SLIDING FORCE". See: Testing and Inspection/Checking Rack Sliding Force
4. If rack sliding force is out of specification adjust rack sliding force again.
5. If rack sliding force can not be adjusted within specification replace steering gear.
INCREASE
Increase rack sliding force as follows:
1. Tighten adjusting screw until it is flush with housing surface.
CAUTION:
^
Do not remove adjusting screw.
^
Steering gear must replaced if adjusting screw is removed or loosened more than two rotations.