Maxima V6-3.5L (VQ35DE) (2007)
3. Disconnect the connecting rod upper link using power tool.
4. Support the wheel hub and steering knuckle assembly with a suitable wire.
5. Remove the shock absorber (strut) lower bolts and nuts using power tool.
6. Remove the three upper shock absorber (strut) mounting nuts using power tool.
CAUTION: Do not remove piston rod lock nut on vehicle.
7. Remove the shock absorber (strut) assembly.
INSTALLATION
Installation is in the reverse order of removal.
^
After installation, check that the front wheel alignment is within specification.
^
When installing the strut spacer, it must be positioned as shown. Tighten all nuts and bolts to specification. Refer to "Components".
WARNING:
^
Always replace the shock absorber (strut) lower mounting nuts.
^
When installing shock absorber (strut) to steering knuckle, be sure to hold bolts when tightening nuts.
^
Install wheel and tire.
Removal and Installation
SHOCK ABSORBER
Removal
1. Remove the wheel and tire using power tools.
2. Set a suitable jack on the rear lower link to remove the lower shock absorber nut and bolt using power tools.
3. Remove the suitable jack from rear lower link.
4. Remove the upper shock absorber nuts using power tools.
5. Remove the shock absorber.
Installation
Installation is in the reverse order of removal.
Inspection
SHOCK ABSORBER ASSEMBLY
^
Check for smooth operation through a full stroke of both compression and extension.
^
Check for oil leaks on the welded or gland packing portions.
^
Check the piston rod for cracks, deformation, or other damage and replace if necessary.