Maxima GLE V6-3.0L (VQ30DE) (1998)
The incident may occur only during high humidity or in rainy/snowy weather. In such cases the incident could be caused by water intrusion on an
electrical part. This can be simulated by soaking the car or running it through a car wash.
Do not spray water directly on any electrical components.
Connector and Terminal Pin Kit
Connector And Terminal Pin Kit
Use the connector and terminal pin kit listed below when replacing connectors or terminals.
The connector and terminal pin kit contains some of the most commonly used NISSAN connectors and terminals.
Introduction
In general, testing electrical circuits is an easy task if it is approached in a logical and organized method. Before beginning, it is important to have all
available information on the system to be tested. Also, get a thorough understanding of system operation. Then you will be able to use the appropriate
equipment and follow the correct test procedure.
You may have to simulate vehicle vibrations while testing electrical components. Gently shake the wiring harness or electrical component to do this.
OPEN A circuit is open when there is no continuity through a section of the circuit.
SHORT There are two types of shorts.
^
SHORT CIRCUIT When a circuit contacts another circuit and causes the normal resistance to change.
^
SHORT TO GROUND When a circuit contacts a ground source and grounds the circuit.
Testing For "OPENS" In the Circuit
Before you begin to diagnose and test the system, you should rough sketch a schematic of the system. This will help you to logically walk through the