Maxima GXE V6-3.0L (VQ30DE) (1999)
Technical Service Bulletin # 92-062A
Date: 990617
Brakes - AMMCO On Car Lathe Operating Guidlines
REFERENCE:
NTB92-062A
CLASSIFICATION:
BR92-004A
DATE:
June 17,1999
TITLE:
AMMCO ON-CAR BRAKE LATHE OPERATING GUIDELINES
APPLIED VEHICLE(S):
All models
This amended version of NTB92-062 adds a CAUTION and a NOTE to the Service Procedure. Please discard all paper copies of NTB92-062.
SERVICE INFORMATION
To ensure the best possible surface finish and least amount of run-out and rotor thickness variation when using the Ammco on-car brake lathe, the
following guidelines should be observed.
Service Procedure
SERVICE PROCEDURE
Before mounting the brake lathe on the vehicle ensure the following:
1. The V-way between the carriage and carriage gib must be clean and adjusted properly (see Operation Manual for adjustment procedure). Wipe off
sliding surfaces with a soft cloth after each use.
2. The cutters and cutting bits must be tight in their mounts and positioned properly. Change cutting bits when they become dull.
3. When securing the adjustable mounting brackets to the caliper mount/knuckle the mounting surfaces must be smooth and free of burrs.
4. Make sure the adjustable mounting brackets are securely mounted to caliper mount/knuckle. There should be no movement between the cutting
tool and the caliper mount/knuckle.
ROTOR DRIVING UNIT
Before using the drive unit ensure the following: