Maxima GXE V6-3.0L (VQ30DE) (1999)
3. Install rear cover plate.
4. Install air compressor and bracket.
5. Install drive belts.
6. Install center member.
7. Install front and rear engine mounting insulator nuts and bolts.
8. Install crankshaft position sensors (POS and REF) and front heated oxygen sensor (left bank) harness clamp.
^
Make sure that crankshaft position sensor (POS) and front heated oxygen sensor (left bank) harness clamp are installed correctly as shown in
figure.
9. Install front exhaust tube and its support.
10. Install oil strainer.
11. Install steel oil pan.
a. Use a scraper to remove all traces of liquid gasket from mating surfaces.
^
Also remove traces of liquid gasket from mating surface of aluminum oil pan.