Maxima GXE V6-3.0L (VQ30DE) (1999)
Service Procedure
NOTE:
This procedure is described using CONSULT-II. CONSULT may also be used to perform the diagnostic procedures outlined below. However, the
screens and steps will differ slightly from those shown here.
Figure 1
1.
Install the NATS card (purple) into slot 1 of CONSULT-II (see Figure 1).
Figure 2
2.
Connect CONSULT-II to the vehicle (see Figure 2).
Figure 3
3.
Turn the ignition switch to "ON" (do not start the engine). CONSULT-II will then turn on automatically (see Figure 3). Now touch "START".