Maxima SE V6-2968cc 3.0L DOHC MFI (VQ30DE) (1997)
Keyless Entry Module: All Technical Service Bulletins
Keyless Entry - No Response to Remote
Classification:
EL97-004
reference:
TB97-040
Date:
May 28, 1997
1995-97 MAXIMA DOES NOT RESPOND TO REMOTE
APPLIED VEHICLE(S):
1995-97 Maxima (A32)
APPLIED VIN(S):
Vehicles built before JN1CA21D*VT808742, JN1CA21 D*VT204048 and JN1CA21D*VM501530
APPLIED DATE(S):
Vehicles built before August 1, 1996
SERVICE INFORMATION
This bulletin provides information to address the concerns of any 1995,1996 or early 1997 Maxima owner who states their vehicle does not always
respond to the remote switches. This incident is a cycle where a customer cites an inoperative remote switch, the dealer reprograms the remotes and the
incident returns for no apparent reason.
Troubleshooting the remote control system per the service manual reveals not problems with the remote batteries, antenna, LCUO5, BCM or wire
harness connections.
Such an incident may be caused by the owner jiggling the ignition key after locking the doors. The sequence of these events erases the remote ID codes
from memory.
There is a countermeasure multi-remote control unit available (which prevents accidental remote ID code erasure) to resolve this incident.
SERVICE PROCEDURE
1.
Interview the customer to see if they usually lock the door before starting the car.
2.
Use the 1996 service manual page EL-225 to test the Multi Remote Control System. Perform the six diagnostic tests for symptom: "All functions
of remote control system do not function".
3.
If the system checks out OK and the customer usually locks the doors before starting the car, replace the multi remote control unit (LCUO5) in the
trunk with the countermeasure unit as follows (see Figure 1):
A.
Remove the right side trunk finisher.