nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Cooling System - Water Pump O-Ring Design Change|Page 3938 > < Cooling System - Water Pump O-Ring Design Change|Page 3936
Page 3
background image

14. Tighten M8 bolts by turning half turn alternately until they reach timing chain rear case. In order to prevent damage to water pump or timing chain

rear case, do not tighten one bolt continuously. Always turn each bolt half turn each time.

15. Lift up water pump and remove it. When lifting up water pump, do not allow water pump gear to hit timing chain.

INSPECTION 

1. Check for badly rusted or corroded body assembly.

2. Check for rough operation due to excessive end play.

INSTALLATION 

1. Apply engine oil and coolant to O-rings as shown in the figure.

Cooling System - Water Pump O-Ring Design Change|Page 3938 > < Cooling System - Water Pump O-Ring Design Change|Page 3936