Maxima SE V6-3.5L (VQ35) (2002)
5. Remove the sensor rotor using suitable puller, drift and bee ring replacer.
INSTALLATION
-
With vehicles equipped with ABS, press-fit ABS sensor rotor into wheel hub bearing using a drift.
Do not reuse ABS sensor rotor. When installing, replace it with a new one.
-
Press-fit ABS sensor rotor as far as the location shown in figure at left.
-
Install wheel hub bearing.
-
Tighten wheel bearing lock nut.
Before tightening, apply oil to threaded portion of rear spindle.
Do not reuse wheel bearing lock nut: 187 - 254 Nm (19 - 26 kgf-cm, 138 - 188 ft. lbs.)
-
Check that wheel bearings operate smoothly.