Maxima SE V6-3.5L (VQ35) (2002)
that the balance weight center is aligned with the wheel balancer indication position (angle).
CAUTION:
-
Always use genuine Nissan adhesion balance weights.
-
Balance weights are unreusable; always replace with new ones.
-
Do not install more than three sheets of balance weight.
c. If calculated balance weight value exceeds 50 g (1.76 oz), install two balance weight sheets in line with each other (as shown in the figure).
CAUTION: Do not install one balance weight sheet on top of another.
3. Start wheel balancer again.
4. Install drive-in balance weight on inner side of road wheel in the wheel balancer indication position (angle).
CAUTION: Do not install more than two balance weights.
5. Start wheel balancer. Make sure that inner and outer residual unbalance values are 10 g (0.35 oz) each or below.
-
If either residual unbalance value exceeds 10 g (0.35 oz), repeat installation procedures.