Maxima SE 20th V6-3.0L (VQ30DE) (2001)
^
ASIST users refer to the "ECM Reprogramming For Nissan Vehicles" general procedure.
4.
Proceed to and perform Final System Check.
Final System Check (All Incident Cases)
1.
Use CONSULT-II to erase all DTCs stored in the ECM.
2.
Confirm that Front Oxygen Sensors H02S1 (B1) and H02S1 (B2) are functioning by performing steps 2A through 2C, below.
NOTE:
Run the vehicle for five minutes before beginning step 2A. Steps 2A and 2B should be performed with the engine at 2000 rpm with no-load
(transmission in Neutral or Park. Parking brake set).
A.
Select "Data Monitor." then "Selection From Menu" in CONSULT-II (see Figure 19).