Maxima SE 20th V6-3.0L (VQ30DE) (2001)
D.
Click the "Continue" button on the ECM Data Reprogramming screen (see Figure 6) to proceed to CONSULT-II setup.
Attachment #1
ATTACHMENT 1 - SPECIAL ECM REPROGRAMMING PROCEDURE FOR ECM I.D. ENTRY
Perform the Download ECM Reprogramming data into CONSULT-II from ASIST procedure below.
CAUTION:
The ECM can be permanently damaged if the Reprogramming procedure is not followed exactly. Do not attempt Reprogramming if the vehicle or
the CONSULT-II batteries are low. Do not disconnect or disturb the CONSULT-II while ECM Reprogramming is in progress. If the ECM is
damaged, it must be replaced, and will not be covered by the vehicle warranty.
Download ECM Reprogramming data into CONSULT-II from ASIST Procedure
IMPORTANT!
^
This is a special ECM reprogram and the following procedure is used FOR THIS INCIDENT ONLY!
^
Step 8 of Download ECM Reprogramming data into CONSULT-II from ASIST has been changed JUST FOR THIS BULLETIN. An ECM ID
CODE must be entered to get the Reprogramming data from ASIST. This is different from the typical ECM Reprogramming procedures now in
use. The ECM ID code is listed in the right hand column of Chart A.
^
For limited application special customer concern incidents like this, the ECM ID CODE will be used. The general procedure for most other
incidents will remain as usual: Enter Model Year and Model to look up ECM data in ASIST.
1.
Remove the Diagnostics Card (blue) and install the ECM Reprogramming Software Card (orange) into slot A of CONSULT-II (see Figure 1).
2a.
Connect the AC power supply to CONSULT-II.