Maxima Wagon V6-2960cc 3.0L SOHC MFI (VG30E) (1986)
12.
After installing the clips, check to make sure the screen is not interfering with the styrofoam case insulation (Figure 8). Remove and adjust the
screen position if necessary.
13.
If the cooling unit case was equipped with rubber inlet and outlet seals, reinstall them. If the cooling unit case was equipped with foam inlet and
outlet seals, install the new seals from the kit.
NOTE: The longer seal is for the outlet side.
14.
Install the cooling unit. Refer to Section HA in the Service Manual for instructions.
NOTE: Be sure to replace the inlet and outlet O-rings with new O-rings. Apply refrigerant oil sparingly to the O-ring and seating surface. Torque
O-ring connector to appropriate specification in Service Manual.
PARTS INFORMATION
CLAIMS INFORMATION
Refer to Section QA in the Warranty Flat Rate Manual for Warranty Information.