Murano AWD V6-3.5L (VQ35) (2003)
^
Tighten the wheel lug nuts to the proper torque specification. Uneven or high torque applied to the lugs may distort the brake rotor and
hub. This may result in increased rotor runout and excessive rotor thickness variation as the rotor wears.
4.
After the rotors have been resurfaced:
^
Recheck the rotor thickness. Specification: 26.0 mm (1.024 in.) minimum thickness.
^
Check the rotor runout. Specification: 0.03 mm (0.001 in) maximum runout.
NOTE:
Runout specification is new, and is slightly less than what is shown in the ESM.
5.
Reinstall the brake caliper assemblies.
^
Refer to the ESM for brake caliper installation instructions.
Install New Front Pads and Hardware Kit