Murano AWD V6-3.5L (VQ35) (2003)
Drive Belt: Testing and Inspection
Checking Drive Belts
WARNING:
-
Be sure to perform when the engine is stopped.
1. Inspect belts for cracks fraying wear and oil. If necessary replace.
2. Inspect drive belt deflection or tension at a point on the belt midway between pulleys.
-
Inspection should be done only when engine is cold or over 30 minutes after engine is stopped.
-
Measure belt tension with tension gauge (B13373-F or equivalent) at points marked V shown in the figure.
-
When measuring deflection apply 98 N (10 kg 22 lb) at the V marked point.
-
Adjust if belt deflection exceeds the limit or if belt tension is not within specifications.