Murano AWD V6-3.5L (VQ35) (2003)
Installation of Intake Manifold Collector (Upper)
Intake Manifold Upper Collector / Torque Sequence
^
Tighten in numerical order as shown in the figure.
17.6 - 21.6 Nm (1.8 - 2.2 kgf-cm, 13 -15 ft. lbs.)
Installation of Intake Manifold Collector (Lower)
Intake Manifold Lower Collector / Torque Sequence
^
Tighten in numerical order as shown in the figure.
17.6 - 21.6 Nm (1.8 - 2.2 kgf-cm, 13 -15 ft. lbs.)
NOTE: Tighten mounting bolts to secure gasket (lower), intake manifold collector (lower), gasket (upper).
Installation of Electric Throttle Control Actuator
^
Install gasket with three protrusions for installation check facing any direction other than upward or downward.
^
Tighten in numerical order as shown in the figure.
: 7.2 - 9.6 Nm (0.74 - 0.97 kgf-cm, 64 - 84 inch lbs.)
^
Perform the "Throttle Valve Closed Position Learning" then harness connector of the electric throttle control actuator is disconnected.
^
Perform the "Idle Air Volume Learning" and "Throttle Valve Closed Position Learning" then the electric throttle control actuator is replaced.