Murano AWD V6-3.5L (VQ35) (2003)
7. Disconnect / remove air duct A from resonator 1.
8. Swap the band clamp from the old air duct A to the new air duct A.
^ Use the original band clamp.
^ Band clamp goes on the throttle body end of air duct A.
^ Make sure the clamp is aligned correctly (rubber stud through hole in clamp as shown).
9. Discard the old air duct A and the old wire clamp.
^ Cut the old air duct A in half and bend the wire clamp so they cannot be reused.
10. Put the new wire clamp on the resonator end of the new air duct A.
CAUTION:
Before installing air duct A, use a clean cloth / rag to wipe away any debris from the duct and resonator.
11. Connect the new air duct A to resonator 1.