Murano AWD V6-3.5L (VQ35) (2003)
4. Disconnect the air bag harness connectors, and remove the driver air bag module.
CAUTION:
-
For installing /removing driver air bag module connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
-
Install connector with lock raised, and push lock into connector.
-
Always work from the side of driver air bag module.
-
Always place driver air bag module with pad side facing upward.
-
Do not insert any foreign objects (screwdriver, etc.) into driver air bag module.
-
Do not disassemble driver air bag module.
-
Do not use old bolts after removal; replace with new bolts.
-
Do not expose the driver air bag module to temperatures exceeding 90 °C (194 °F).
-
Replace driver air bag module if it has been dropped or sustained an impact.
-
Do not allow oil, grease or water to come in contact with the front passenger air bag module.
INSTALLATION
Install in the reverse order of removal.
-
For installing the air bag module, tighten the special bolts (TORX bolts).
-
After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to "SRS Operation Check" See: Testing and
Inspection/Component Tests and General Diagnostics
Front Passenger Air Bag Module
REMOVAL
CAUTION:
-
Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
-
Always work from the side of or under front passenger air bag module.
1. Remove instrument passenger lower panel and glove box assembly.