Murano AWD V6-3.5L (VQ35) (2003)
Impact Sensor: Service and Repair
Crash Zone Sensor
REMOVAL
CAUTION: Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
1. Remove front grille.
2. Remove crash zone sensor connector.
3. Remove crash zone sensor fixing nuts.
CAUTION:
-
Replace crash zone sensor if it has been dropped or sustained an impact.
-
Do not disassemble crash zone sensor.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Check crash zone sensor for proper installation.
-
After the work is complete, perform self-diagnosis to make sure no malfunction is detected. Refer to "SRS Operation Check" See: Testing and
Inspection/Component Tests and General Diagnostics