Murano AWD V6-3.5L (VQ35) (2003)
![background image](/nissan/murano_awd/v6-3.5l_(vq35)/Page-250001.png)
Knock Sensor: Service and Repair
Installation
Install knock sensor.
^
Make sure that there is no foreign material on the cylinder block mating surface and the back surface of the knock sensor.
^
Install knock sensor so that connector faces front of engine.
^
Do not tighten the mounting bolts while holding the connector.
^
Make sure that the knock sensor does not interfere with other parts.
CAUTION: If any impact by dropping is applied to the knock sensor, replace it with new one.
^
After installing knock sensor, connect sub-harness, and lay it out to rear of engine.