Murano AWD V6-3.5L (VQ35) (2003)
8. Install boot securely into grooves (indicated by * marks) shown in the figure.
CAUTION: If there is grease on boot mounting surfaces (indicated by * marks) of shaft and housing, boot may come off. Remove all grease
from surfaces.
9. Make sure boot installation length "L" is the length indicated below. Insert a flat-bladed screwdriver or similar tool into smaller side of boot.
Bleed air from boot to prevent boot deformation.
Boot installation length "L" : 96.5 mm (3.8 inch)
CAUTION:
^
Boot may break if boot installation length is less than standard value.
^
Take care not to touch the tip of screwdriver to inside of boot.
10. Secure big and small ends of boot with new boot bands as shown in the figure.
CAUTION: Discard old boot band; replace with new ones.
11. After installing housing and shaft, rotate boot to check whether or not the actual position is correct. If boot position is not correct, secure boot
with new boot band again.
Wheel Side
1. Insert the amount of grease (NISSAN genuine grease or equivalent) into joint sub-assembly serration hole until grease begins to ooze from ball
groove and serration hole. After inserting grease, use a shop cloth to wipe off old grease that has oozed out.