Murano AWD V6-3.5L (VQ35) (2003)
3. Check the CONSULT-II's "Charger Input" reading (see Figure D).
NOTE:
^
"Battery Voltage" is the voltage level of CONSULT-II's battery.
^
"Charger Input" is the voltage level of the vehicle's battery. (It must be above 12 volts.)
CAUTION:
^
If the "Charger Input" is below 12 volts:
^
A list of items to check when "Charger Input" voltage is below 12V is contained in the "TCM Reprogramming For Nissan Vehicles" general
procedure.
^
The "TCM Reprogramming For Nissan Vehicles" general procedure can also be found in the print copy of this bulletin.
Step Three: Reprogram the TCM
Step Four: TCM Reprogramming "Wrap-up"
1. Turn the ignition and CONSULT-II OFF.
2. Disconnect CONSULT-II from the vehicle.
3. Start the Engine and make sure the MIL is OFF.
^
If it's still ON, use CONSULT-II with the Diagnostic (red/white) Card to erase any DTC's that may have stored in the TCM and/or the ECM during
the reprogramming procedure.
4. Test-drive the vehicle and make sure the transmission operates correctly in all modes.
^
See the AT section of the appropriate Service Manual for operation specifications.