Murano AWD V6-3.5L (VQ35DE) (2009)
Front Bumper: Service and Repair
Removal And Installation
FRONT BUMPER
Removal and Installation
REMOVAL
CAUTION:
Bumper fascia is made of resin. Do not apply strong force to it, and be careful to prevent contact with oil.
1. Fully open hood assembly.
2. Remove front grille. Refer to See: Grille/Service and Repair/Removal And Installation.
3. Remove headlamp extension panel. Refer to See: Lighting and Horns/Headlamp/Service and Repair/Removal And Installation/Xenon Type.
4. Remove clips (A) of bumper fascia assembly (1) upper side.
5. Remove fender protector fixing clips (A) (LH/RH).
6. Remove front under cover and bumper lower finisher (LH/RH). Refer to See: Interior Moulding / Trim/Service and Repair/Floor Side
Fairing/Exploded View.
7. Remove bumper fascia assembly fixing bolts (A).
8. Remove bumper fascia assembly fixing screws (A) (LH/RH).
9. Disconnect front fog lamp harness connector (LH/RH).