Murano AWD V6-3.5L (VQ35DE) (2009)
Parking Brake Shoe: Service and Repair
Removal and Installation
PARKING BRAKE SHOE
Removal and Installation
REMOVAL
WARNING:
Clean any dust from the parking brake shoes and back plates with a vacuum dust collector. Never blow with compressed air.
1. Remove rear tires with power tool.
2. Remove disc rotor. Refer to See: Disc Brake System/Brake Caliper/Service and Repair/Removal and Replacement/Rear Disc Brake/Removal And
Installation.
CAUTION:
Parking brake completely in the released position.
3. If disc rotor cannot be removed, remove as follows:
a. Fix the disc rotor with wheel nuts and remove the adjusting hole plug.
b. Using suitable tool, rotate adjuster (1) in direction (B) to retract and loosen parking brake shoe.
4. Remove anti-rattle pins, retainers, anti-rattle spring, adjuster spring and return springs.
CAUTION:
Never drop the removed parts.
5. Remove parking brake shoes, adjuster assembly and toggle lever.
CAUTION:
-
The parking brake shoes for the front side are made of different materials from those for the rear side. Never misidentify them when
removing.
-
Never drop the removed parts.
INSTALLATION
Install in the reverse order of removal.
-
Apply PBC (Poly Butyl Cuprysil) grease or silicone-based grease to the back plate and brake shoe.
CAUTION:
The parking brake shoes for the front side are made of different materials from those for the rear side. Never misidentify them when
removing and replacing.
-
Assemble adjusters so that threaded part is expanded when rotating it in the direction shown by arrow.