Murano AWD V6-3.5L (VQ35DE) (2009)
C : Measuring point
Standard and limit : Refer to See: Specifications
-
If the measured value exceeds the limit, replace piston ring, and measure again. If it still exceeds the limit, re-bore cylinder and use oversize piston
and piston rings.
CONNECTING ROD BEND AND TORSION
-
Check with a connecting rod aligner.
A : Bend
B : Torsion
C : Feeler gauge
Bend limit Torsion limit : Refer to See: Specifications
-
If it exceeds the limit, replace connecting rod assembly.
CONNECTING ROD BIG END DIAMETER
-
Install connecting rod bearing cap without installing connecting rod bearing, and tightening connecting rod bolts to the specified torque. Refer to
See: Service and Repair/Disassembly And Assembly for the tightening procedure.
1 : Connecting rod
-
Measure the inner diameter of connecting rod big end with an inside micrometer.
Standard : Refer to See: Specifications
-
If out of the standard, replace connecting rod assembly.
CONNECTING ROD BUSHING OIL CLEARANCE
Connecting Rod Bushing Inner Diameter
Measure the inner diameter of connecting rod bushing with an inside micrometer (A).